Emergency measures for car half anchoring
Explosion-Proof Floor Scale,Explosion-Proof 10T Floor Scale,Explosion-Proof Electronic Platform Floor Scale,Explosion-Proof Industrial Floor Weighing Scale Jiangsu Lude Electrical Manufacturing Co.,Ltd , https://www.ludescale.com
Don't forget that you need to put repair tools and spare emergency parts in the luggage compartment. And use 24 hours emergency towing rescue service, or please help by the vehicle back to the original factory maintenance; the other half of the anchor should have the correct safety instructions, warning to the car.
In case of an anchor on an unsupervised railway, if the time of the train approaching is still early, then use one gear or reverse gear to get out of danger. If the battery becomes weak and the motor cannot be started and there is no time for moving the vehicle, the device must be notified of the danger in advance by means of a fault reporting device or unusual signal device on the plane crossing.
The starter motor can not start the trolley with a strike, and uses its inertia to start the car. The method is: Put the gear on the 2nd or 3rd gear. After the clutch pedal is pressed, ask the person to push the cart; if there is inertia, it will ignite, and immediately connect the clutch, and the engine will immediately step on the clutch.
When the tire burst, tell the follow-up car and remove the foot from the driving pedal. When driving, the steering wheel is biased to one side. When the body feels abnormal vibration, it is hurried to judge whether it is a flat tire. If it is determined to be a flat tire, do not hurry to turn the steering wheel. Or emergency car, you should immediately signal to the follow-up car and remove your foot from the driving pedal, do not immediately leave the driveway by holding the steering wheel with your hand, and wait until the speed is reduced to stop the car to a safe place on the roadside. When it is overheating, you can't rush to remove the indicator of the water tank cover water thermometer to h --- unable to slap softly to emit steam out of the metal tone water tank. This is overheating, and the method is to stop the engine at a low speed through parking. Open the engine cover so that it is well ventilated. When the striker completely cools, let the steam disperse to the pipe next to the water inlet, and slowly open the tank cover to check the cooling water.