The water tank radiator and the intercooler (intercooler) of the truck crane are all installed in one place. It is the front of the engine of the vehicle. It depends on the suction fan and the vehicle passes through the wind when driving. For cooling, if there is a malfunction in the intercooler attached to the vehicle, it will cause the engine to have insufficient power, and it will also increase fuel consumption. Therefore, the inspection and maintenance of the intercooler need to be established. A suitable time:

Because the intercooler of the truck crane is installed at a relatively high position, the intercooler of the vehicle is often blocked by those sludges or leaves and other impurities, which may cause the intercooler to have heat dissipation. In a bad situation, it needs to be cleaned in a certain period of time. When cleaning, flush with water guns of moderate pressure in a sequence that is perpendicular to the plane of the intercooler, from top to bottom, from bottom to top. The water gun cannot be slid because This may cause damage to the intercooler.

The internal pipes in the intercooler of the truck crane are often exposed to gum and sludge. This will not only make the air flow passage very narrow, but also reduce the cooling heat exchange performance. Therefore, the interior of the intercooler needs to be checked regularly and the cleaning work must be maintained.

You can use an aqueous solution of 2% soda ash to fill the intercooler. After filling it up, wait quietly for a quarter of an hour to see if there is any leak in the intercooler under the crane. If no water seepage occurs, it can be rejuvenated before and after it is repeated several times. Finally, the cleansing solution is drained, and the cleansing solution containing 2% pure liquid is flushed again until it Clean up so far. If the outside of the intercooler on which the vehicle is mounted is stained with oil, alkaline water can also be used for cleaning.

Bearing Housing is a most important component of conveyor rollers, and Conveyor Roller is a most important component of belt conveyor. 

Our stamping roller bearing housings are with high precision, since they will be stamped at least 3-5 times with precise molds.

We have almost 25 years' experience in producing different Bearing Housing Types. 

There are 9 stamping production lines to produce Bearing Block .

Also there's robot stamping lines to produce Bearing House . 

Our Stamped Bearing Housing has been exported to many different countries. 

Bearing Housing

Bearing Housing,Bearing Housing Types,Roller Bearing Housing,Bearing Seat

Qufu Zhuoyue Heavy Industry Science&Technology Co., Ltd , https://www.zhuoyueindustry.com