Water Truck Introduction
Sprinklers, also known as water tankers, water trucks or sprayers, play a pivotal role in urban construction. The sprinklers that are commonly seen are sprayed on the green belts on both sides of the city road or in the middle. However, in addition to cleaning and maintaining the green belts, the sprinklers are also used in the construction of construction companies, high-rise buildings, and various road areas. Big application. In addition to flushing, sprinklers also have functions such as pesticide spraying, guardrail rinsing, water transport, drainage, and emergency firefighting. Therefore, in terms of function, sprinklers can be classified into green sprinklers, water sprinklers, and fire sprinklers. Common sprinklers generally consist of chassis, tanks, piping systems, sprinklers, cabs, power take-offs, sprinklers, etc. The piping system is a system of pipes, ball valves, filters, and outlets. In two-step operation, the first step is to absorb water. The specific operation steps are: after parking, remove the water-absorbing rubber hose from the walk-out box and swing the hose backwards until the hose is not bent. Then, insert the water-absorbing hose into the water as deep as possible, and keep the difference between the tube and the liquid level always greater than 3cm. Push the four-way valve handle to the direction perpendicular to the ground, and then put the transmission into neutral, start the engine and separate. Clutch, pull the force again, the pump starts running. When the liquid level reaches the middle of the sight glass, quickly pull the suction hose away from the water or close the four-way valve. In this way, the water absorption step is completed. The second step is spraying. First, pull the rear handle of the four-way valve to the direction parallel to the ground, open the ball valve you want to spray (front flush, back spray, side spray, shower), and then start the engine and put the transmission into gear. Position the power take-off switch back and pull it out to pull the force. Then the clutch is disengaged, the pump starts to run, and the water sprinkling starts. After the sprinkled water is finished, the gear should be immediately released and the sprinkler pump should be stopped.
DNDT series industrial online inspection radiography
system usually applies with leading C-arm structure, it always transmits
workpiece into lead room by table roller, and also can connects with workpiece
production line to be flow inspection, with cooperation between X-ray and
industrial TV, users can view real time inspection images directly, which can
easier judge appearance and type of failure, then finish saving and processing
for the picture to improve its definition.
As most important part of radiography system-image
intensifier/flat panel detector, we applies with products which manufactures by
famous France Thales/Pelkinelmer, varian company, it not only has advantages of
high resolution and low noise, but also with characteristic of big dynamic
range which can offer reliable image information for users.
Electrical controlling unit is an intelligent controlling
system which with core of PLC, it matches with servo driver and rotation coder
which can finish relative inspection procedure and collects images by manual/
semi-auto modes after diameter alignment of different workpiece models.
Online Inspection System Online Inspection System,Pipe Online Inspection System,Tyre Online Inspection System,Steel Wheel Online Inspection System Dandong Nondestructive Testing Equipment Co., Ltd. , http://www.ddchinaxray.com
