The failure of a car brake is a terrible thing, because if the brakes in the process of driving the car fails, it is likely to cause an unimaginable tragedy. Here to tell you how to handle the brake failure?

Case downhill with a small brake

Usually when driving down the slope with a small foot brake, to develop a good habit of test braking. Once you find a problem with the brakes, if the speed is not too fast, try to pull the handbrake to see if you can slow down the speed. Pull the handbrake attention, do not pull too fast too fast, if a dead hand brake, due to the speed, inertia and other factors, it is likely to cut off the rope, we must use slow, slowly pull the handbrake.

Try changing gears

If the handbrake is not working, try to block it and see if the gear can be adjusted from high to low. In particular, Bigfoot hits the throttle, retreats, and then hits the throttle, enters the file, because if there is no brake when downhill, due to inertia, the speed will be faster and faster, the gearbox has been difficult to open and close, most of the grab is not Into the low gear. By giving big feet to the oil, the synchronizer is opened and the low gear is forced to slow down the speed. Then, with the handbrake, the car is slowly stopped.

Open to the roadside

If you can't do it, check if there are mountains. If so, it is best to rely on the right side of the mountain. Slowly drive the car to the side of the road and hold the steering wheel to the side of the mountain. With the scraping of the body and the mountain, it is not a collision. Use the entire area of ​​the right side of the car to make contact with the mountain to increase the friction and make the car faster. Stop.

Looking for trees, flowers and bushes

If there is no mountain, then it depends on whether trees are available on the roadside. If yes, the processing method is the same as above. If not, look for other things like buildings nearby. In short, the above method is almost as above, and the flexible application is.

Go to soft soil, open in the sand

If all of the above conditions are not available, it would be okay if it was a straight road. Maybe the front could be stopped on an uphill slope. If you see a decelerating sand pile next to it, head forward and you will stop and stop.

   Pipe Union

Pipe union is a kind of High Pressure Forged Fittings, include class3000 and class 6000. It has two different types, one is socket welding union, the other is Threaded Union.Materials for union are carbon steel, alloy steel, stainless steel and nickel alloy.The size range is from 1/8`` to 3``.

About threaded union, you will find screw on the inside of it. It is also called Screw Pipe Union. Internal pipe threads shall be NPT comply with ASME ASME B1.20.1 Standard.

CLASS 3000 pipe unions, the end is socket welding.

No matter which type of Forged Pipe Union, the standard shall meet the requirements of MSS SP-83.

Pipe Union

Forged Pipe Union,Threaded Union,Screw Pipe Union

CANGZHOU HENGJIA PIPELINE CO.,LTD , https://www.hj-pipeline.com