How often should the fire protection maintenance be known to you?
This epoxy coating impregnation technology refers to coating epoxy powder of the stators for impregnation after hot-melting of the copper welding terminals of copper coils, before curing with high heat. It boasts the advantage of automatic powder dust cleanup and higher production accuracy.
Automatic stator coating with epoxy material at welding ends of the stators, before solidified to form a protective layer, including the material fluidization, cycling and recovery, as well as the product preheating and curing. With data traceability system, product quality is controllable. The cycle time, automation and production accuracy can be customized.
Stator Epoxy Coating Machine,Efficient Epoxy Coating Line,Automatic Stator Coating Line,Ev Motor Stator Impregnation Line Wujiang Jinlan Machinery Manufacture Co.,Ltd , https://www.jinlan-technology.com
Monitoring module:
Simulate the alarm signal (or short the module input terminal) on the monitored equipment device. The module confirms that the lamp should be always on or check the alarm condition on the controller.
Where false alarms and failures occur in the monitoring module, first check that the wiring and address codes are correct and correct. Then use a good module installed in this location to determine if it is a module failure. If the module is misreported or faulty, check for moisture and other damage. After eliminating external causes, the BGY-368 should be used to clean the integrated circuit and address code. If it still cannot be used normally, it must be replaced.
Input and output modules:
On the controller or according to the programming simulation control module action signal, the input/output module confirms that the light should be always on, and there is a 24V DVC output on the module terminal.
Where false alarms and faults occur in the input and output modules, first check that the wiring and address codes are correct and correct. Then use a good module installed in this location to determine if it is a module failure. If the module is misreported and faulty, check if it is damp, and if there is any other damage. After eliminating external causes, the BGY-368 should be used to clean the integrated circuit and address code. If it still cannot be used normally, it must be replaced.